solar panel
Which Solar Panel Suits Your Needs: 12V Or 24V?
October 20, 2021
water industry
Different Revolution In Power And Water Industry Of Pakistan
November 2, 2021

Water Purifier Problems: How Can You Get Rid Of Them?

water purifier

If you have maintained an RO plant or water purifier properly, it can be used for 4 to 5 years without any problems. After that, you may start to face some water cleaning problems. Drainage is not the only problem with running water that people face.

Various other problems can arise after using water filters for years, including unusual taste and smell, noisy faucet, and slow water flow. In this article, we have listed these water purification problems and their answers so that you can identify and solve theproblems quickly.

Get Rid Of These Water Purifier Problems Easily 

The nasty smell from the purifier

If the water of RO or UV water purifiers has a strong odor or special taste, it may be because the biofilm is concentrated in one or more of the water purifiers. Biofilm is a layer of plant material and an invisible substance collected on top of a water filter.

As a result, water pollution levels rise. The most immediate solution, in this case, is to replace any filters or covers. After replacing the filters, you can check whether the taste or smell is good. Be sure to replace the filters every 12 months as recommended by the famous RO plants distributors and suppliers.

The RO plant uses a copper pipe. If you see the taste of metal in water, it means that water can dissolve large amounts of sulfate, chloride, and bicarbonate in copper pipes, leaving the taste of metal in the water.

Similarly, if you find that the water in soap has a slightly salty taste, it means that the salt and other solids have dissolved in the water. The RO water purifier should work well to remove these particles in the water. If the water in your cleaning is more pleasant than before, you should call a professional for a thorough inspection as well as a cleaner.

This procedure should be done every six months. 

Compromised water flow 

If your water purifier releases clean water slowly and only half this glass is filled at a time, it is for your water volume or low water pressure. RO usually requires a minimum pressure of 40 to 60 PSI (pounds per square inch) to function properly, which is achievable if you install a reliable diesel generator for increasing water output.

It is possible that the water storage tank of the purifier is not working, causing this problem. The water storage tank of the washer has an airbag, so the water can be drained quickly. The higher the water level, the greater the pressure.

If the bladder is draining, it may not provide the full range of exercise, bringing in slower flow through the drain hose. Filters of water filters can also close due to high sediment content, which can cause water to flow slowly. If the lock is dry, ask a cleaning professional to replace it.

Unusual noise from the faucet

If you hear noises coming from the water pump, especially when the filters are replaced on the skin, it is due to the air leaking into the system. This may also be due to changes in water pressure in the system.

If the filter does not stop soon, please call a professional who also deals in reliable solar panels to make sure the pipe is properly installed. If the wave of the water tank does not close properly, noise may occur.

Read more: Process of changing the house water filter

Leave a Reply

Your email address will not be published. Required fields are marked *

Product Enquiry